Dell Force10 Z9000 - Show Ip Msdp

Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 6.2.1.1 Introduced
show ip msdp
Display the MSDP peer status, SA cache, or peer summary.
E-Series, Z-Series, S4810
Syntax
show ip msdp {peer peer address | sa-cache | summary}
Parameters
peer peer
address
Enter the keyword peer followed by the peer address in a dotted
decimal format (A.B.C.D.).
sa-cache Enter the keywords sa-cache to display the Source-Active cache.
summary Enter the keyword summary to display a MSDP peer summary.
Defaults Not configured.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 6.2.1.1 Introduced
Example
FTOS#show ip msdp peer 100.1.1.1
Peer Addr: 100.1.1.1
Local Addr: 100.1.1.2(639) Connect Source: none
State: Established Up/Down Time: 00:00:08
Timers: KeepAlive 60 sec, Hold time 75 sec
SourceActive packet count (in/out): 0/0
SAs learned from this peer: 0
SA Filtering:
Input (S,G) filter: none
Output (S,G) filter: none
FTOS#
Example (Sa-
cache)
FTOS#show ip msdp sa-cache
MSDP Source-Active Cache - 1 entries
987