Dell Force10 Z9000 - Determining Chassis Mode

2. Enter the config-vlt-domaincommand.
You can return to CONFIGURATION mode by entering the exit command.
OPENFLOW INSTANCE Mode
Use OPENFLOW INSTANCE mode to enable and configure OpenFlow instances. For more information, refer to SDN
Commands.
To enter OPENFLOW INSTANCE mode:
1. Verify that you are logged into CONFIGURATION mode.
2. Enter the openflow of-instance command followed by the OpenFlow ID number of the instance you want
to create or configure. The prompt changes to include (conf-of-instance of-id).
You can return to the CONFIGURATION mode by entering the exit command.
Determining Chassis Mode
Chassis mode in FTOS determines which hardware is being supported in an E-Series chassis.
Chassis mode is programmed into an electrically erasable programmable read-only memory (EEPROM) on the backplane
of the chassis and the change takes place only after the chassis is rebooted. Configuring the appropriate chassis mode
allows the system to use all the ports on the card and recognize all software features.
56