stop jumpstart
Stop the switch from reloading in BMP mode to prevent an infinite loop.
Z-Series, S4810
Syntax
stop jumpstart
NOTE: This command has been deprecated. It has been replaced by the disable-bmp
command.
Defaults none
Command Modes CONFIGURATION
Command History
Version 9.1(0.0) Deprecated command. Replaced by the disable-bmp command.
Version 8.3.11.4 Introduced on the Z9000.
Version 8.3.10.1 Introduced for the S4810.
Usage
Information
Use the stop jumpstart command on a switch running BMP 2.0 if the switch enters a
loop while reloading in jumpstart mode; loop occurs when the switch is continuously trying to
contact a DHCP server and a DHCP server is not found. The stop jumpstart command
stops the switch from connecting to the DHCP server. After you use the
stop jumpstart
command, the next default reload type is a normal reload. This is indicated in the show
reload-type command.
Related
Commands
reload type – configures the reload mode as normal or jumpstart (BMP).
545
To Next Page
Loading...
