show ip ospf database opaque-area
Display the opaque-area (type 10) LSA information.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip ospf process-id database opaque-area [link-state-id]
[adv-router ip-address]
Parameters
process-id
Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
link-state-id
(OPTIONAL) Specify LSA ID in dotted decimal format. The LSA ID
value depends on the LSA type, and it can be one of the following:
• the network’s IP address for Type 3 LSAs or Type 5 LSAs
• the router’s OSPF router ID for Type 1 LSAs or Type 4 LSAs
• the default destination (0.0.0.0) for Type 5 LSAs
adv-router
ip-
address
(OPTIONAL) Enter the keywords adv-router and the ip-address to
display only the LSA information about that router.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
The following describes the show ip ospf process-id database opaque-area
command shown in the Example below.
Item Description
LS Age Displays the LSA’s age.
Options Displays the optional capabilities available on router. The following
options can be found in this item:
• TOS-capability or No TOS-capability is displayed depending
on whether the router can support Type of Service.
• DC or No DC is displayed depending on whether the
originating router can support OSPF over demand circuits.
1083
To Next Page
Loading...
