Dell Force10 Z9000 - Ip Max-Frag-Count

Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced for the E-Series.
ip max-frag-count
Set the maximum number of fragments allowed in one packet for packet re-assembly.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip max-frag-count count
To place no limit on the number of fragments allowed, use the no ip max-frag-count
command.
Parameters
count Enter a number for the number of fragments allowed for re-assembly.
The range is 2 to 256.
Defaults No limit is set on number of fragments allowed.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced for the E-Series.
Usage
Information
To avoid denial of service (DOS) attacks, keep the number of fragments allowed for re-
assembly low.
790