system-mac
Reconfigure the default MAC address for the domain.
Z-Series, S4810
Syntax
system-mac mac-address
Parameters
mac-address Enter the system MAC address for the VLT domain.
Defaults Not configured.
Command Modes VLT DOMAIN
Command History
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
Usage
Information
When you create a VLT domain on a switch, FTOS automatically creates a VLT-system MAC
address used for internal system operations.
Use the system-mac command to reconfigure the default MAC address for the domain by
entering a new MAC address in the format nn:nn:nn:nn:nn:nn..
You must also reconfigure the same MAC address on the VLT peer switch.
unit-id
Explicitly configure the default unit ID of a VLT peer switch.
Z-Series, S4810
Syntax
unit-id [0 | 1]
Parameters
0 | 1 Configure the default unit ID of a VLT peer switch. Enter 0 for the first
peer or enter
1 for the second peer.
Defaults Automatically assigned based on the MAC address of each VLT peer. The peer with the lower
MAC address is assigned unit 0; the peer with the higher MAC address is assigned unit 1.
Command Modes VLT DOMAIN
Command History
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
Usage
Information
When you create a VLT domain on a switch, FTOS automatically assigns a unique unit ID (0 or
1) to each peer switch. The unit IDs are used for internal system operations. Use the unit-id
1466
To Next Page
Loading...
