Dell Force10 Z9000 - Show Ntp Status

Field Description
disp Displays the dispersion.
Example
FTOS#show ntp associations
remote ref clock st when poll reach delay offset disp
=============================================================
10.10.120.5 0.0.0.0 16 - 256 0 0.00 0.000 16000.0
*172.16.1.33 127.127.1.0 11 6 16 377 -0.08 -1499.9
104.16
172.31.1.33 0.0.0.0 16 - 256 0 0.00 0.000 16000.0
192.200.0.2 0.0.0.0 16 - 256 0 0.00 0.000 16000.0
* master (synced), # master (unsynced), + selected, - candidate
FTOS#
Related
Commands
show ntp status – displays the current NTP status.
show ntp status
Display the current NTP status.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ntp status
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
The following describes the show ntp status command shown in the Example below.
Field Description
“Clock is...” States whether or not the switch clock is synchronized, which NTP
stratum the system is assigned and the IP address of the NTP peer.
“frequency is...” Displays the frequency (in ppm), stability (in ppm) and precision (in
Hertz) of the clock in this system.
“reference time is...” Displays the reference time stamp.
1442