as-path-name
Enter the name of an established AS-PATH access list. If you do not
configure the AS-PATH access list, the default is permit (to allow
routes). The maximum is 16 characters.
in Enter the keyword in to filter inbound BGP routes.
out Enter the keyword out to filter outbound BGP routes.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
neighbor maximum-prefix
Control the number of network prefixes received.
C-Series, E-Series
Syntax
neighbor {ipv6-address | peer-group-name} maximum-prefix
maximum [threshold] [warning-only]
To return to the default values, use the no neighbor {ipv6-address | peer-
group-name} maximum-prefix maximum [threshold] [warning-only]
command.
Parameters
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group-name
Enter the name of the peer group.
maximum
Enter a number as the maximum number of prefixes allowed for this
BGP router. The range is 1 to 4294967295.
threshold
(OPTIONAL) Enter a number to be used as a percentage of the
maximum value. When the number of prefixes reaches this
percentage of the maximum value, the E-Series software sends a
message. The range is 1 to 100 percent. The default is 75.
warning-only (OPTIONAL) Enter the keywords warning-only to set the router to
send a log message when the maximum value is reached. If you do
not set this parameter, the router stops peering when the maximum
number of prefixes is reached.
Defaults threshold = 75
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
485
To Next Page
Loading...
