Dell Force10 Z9000 - Output-Delay

• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
When the offset metric is applied to an interface, that value takes precedence over an offset
value that is not extended to an interface.
Related
Commands
ip prefix-list – enters PREFIX-LIST mode and configure a prefix list.
output-delay
Set the interpacket delay of successive packets to the same neighbor.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
output-delay delay
To return to the switch software defaults for interpacket delay, use the no output-delay
command.
Parameters
delay Specify a number of milliseconds as the delay interval. The range is 8
to 50.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
1248