Dell Force10 Z9000 - Telnet

telnet
Connect through Telnet to a server. The Telnet client and server in FTOS support IPv4 and IPv6 connections.
You can establish a Telnet session directly to the router or a connection can be initiated from the router.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
telnet {host | ip-address | ipv6-address prefix-length | vrf
vrf instance name } [/source-interface]
Parameters
host Enter the name of a server.
ip-address Enter the IPv4 address in dotted decimal format of the server.
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format followed by the prefix
length in the /x format. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
vrf instance (Optional) E-Series Only: Enter the keyword vrf followed by the VRF
instance name.
source-interface (OPTIONAL) Enter the keywords /source-interface followed
by the interface information to include the source interface. Enter the
following keywords and slot/port or number information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Loopback interface, enter the keyword loopback
followed by a number from zero (0) to 16383.
• For the Null interface, enter the keyword null followed by 0.
• For a Port Channel interface, enter the keyword port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For SONET interface types, enter the keyword sonet
followed by the slot/ port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a VLAN interface, enter the keyword vlan followed by a
number from 1 to 4094.
Defaults Not configured.
Command Modes
• EXEC
186