Dell Force10 Z9000 - Fip-Snooping Fc-Map; Fip-Snooping Port-Mode Fcf

fip-snooping fc-map
Configure the FC-MAP value FIP snooping uses on all VLANs.
S4810 and MXL Switch
Syntax
fip-snooping fc-map fc-map-value
To remove the configured FM-MAP value, use the no fip-snooping fc-map command.
Parameters
fc-map-value Enter the FC-MAP value FIP snooping uses. The range is 0EFC00 to
0EFCFF.
Defaults 0x0EFC00
Command Modes
• CONFIGURATION
• VLAN INTERFACE
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
fip-snooping port-mode fcf
Configure the port for bridge-to-FCF links.
S4810 and MXL Switch
Syntax
fip-snooping port-mode fcf
To disable the bridge-to-FCF link on a port, use the no fip-snooping port-mode fcf
command.
Command Modes INTERFACE
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The maximum number of FCFs supported per FIP snooping-enabled VLAN is four.
628