Dell Force10 Z9000 - Bfd Neighbor; Bfd Protocol-Liveness

bfd neighbor
Establish a BFD session with a neighbor.
C-Series, E-Series, Z-Series, S4810
Syntax
bfd neighbor ip-address
To remove the BFD session with the neighbor, use the no bfd neighbor ip-address
command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format
(A.B.C.D).
Defaults none
Command Modes INTERFACE
Command History
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.10.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.5.1.0 Added support for VLAN and port-channel interfaces on the E-Series.
Version 7.4.1.0 Introduced on the E-Series.
Related
Commands
show bfd neighbors – displays the BFD neighbor information on all interfaces or a specified
interface.
bfd protocol-liveness
Enable the BFD protocol liveness feature.
E-Series, Z9000, S4810
Syntax
bfd protocol-liveness
Defaults Disabled
Command Modes CONFIGURATION
Command History
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.10.0 Introduced on the S4810.
Version 7.4.1.0 Introduced on the E-Series.
317