Dell Force10 Z9000 - Disable-On-Sfm-Failure; Duplex (Management)

Related
Commands
show interfaces description – displays the description field of the interfaces.
disable-on-sfm-failure
Disable select ports on E300 systems when a single switch fabric modules (SFM) is available.
E-Series
Syntax
disable-on-sfm-failure
To delete a description, use the no disable-on-sfm-failure command.
Defaults Port is not disabled.
Command Modes INTERFACE
Command History
Version 7.7.1.0 Introduced on the E300 systems only.
Usage
Information
When an E300 system boots up and a single SFM is active on this configuration, any ports you
configure with this feature are shut down. If an SFM fails (or you remove) in an E300 system
with two SFM, the ports you configure with this feature are shut down. All other ports are
treated normally.
When you install or replace a second SFM, all ports are booted up and treated as normally.
This feature does not take affect until a single SFM is active in the E300 system.
duplex (Management)
Set the mode of the Management interface.
C-Series, E-Series, Z-Series
Syntax
duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half Enter the keyword half to set the Management interface to transmit
only in one direction.
full Enter the keyword full to set the Management interface to transmit
in both directions.
Defaults Not configured.
Command Modes INTERFACE
693