Dell Force10 Z9000 - Ipv6 Prefix-List; Distance Bgp

Version 7.4.1.0 Introduced
Related
Commands
router bgp – Enter ROUTER mode on the switch.
distance bgp
Configure three administrative distances for routes.
C-Series, E-Series
Syntax
distance bgp external-distance internal-distance local-distance
To return to default values, use the no distance bgp command.
Parameters
external-distance Enter a number to assign to routes learned from a neighbor external
to the AS. The range is 1 to 255. The default is 20.
internal-distance Enter a number to assign to routes learned from a router within the
AS. The range is 1 to 255. The default is 200.
local-distance Enter a number to assign to routes learned from networks listed in the
network command. The range is 1 to 255. The default is 200.
Defaults
• external-distance = 20
• internal-distance = 200
• local-distance = 200
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
Usage
Information
CAUTION: Dell Force10 recommends that you do not change the administrative distance of
internal routes. Changing the administrative distances may cause routing table
inconsistencies.
The higher the administrative distance assigned to a route means that your confidence in that
route is low. Routes assigned an administrative distance of 255 are not installed in the routing
table.
Routes from confederations are treated as internal BGP routes.
ipv6 prefix-list
Configure an IPv6 prefix list.
Z-Series, S4810
Syntax
ipv6 prefix-list prefix-list name
477