Dell Force10 Z9000 - Show Cam Layer3-Qos

00:00:00:00:ff:ff - - 7
01818 0 - 0 00:00:00:00:00:c0...00:00:00:00:00:d0
00:00:00:00:00:f0 - 45 5
01819 0 4 0 00:00:00:a0:00:00...00:00:00:b0:00:00
00:00:00:ff:00:00 4 - 4
01820 0 - 0x2000 00:00:00:00:00:00...00:00:00:00:00:b0
ff:ff:ff:ff:ff:ff - - 1
02047 0 - 0 00:00:00:00:00:00...00:00:00:00:00:00
00:00:00:00:00:00 - - 0
FTOS#
show cam layer3-qos
Display the Layer 3 QoS CAM entries.
E-Series
Syntax
show cam layer3-qos {[linecard number port-set number] |
[interface interface]} [summary]
Parameters
linecard number Enter the keyword linecard followed by the line card slot number.
For the E-Series, the range is 0 to 13 on a E1200, 0 to 6 on a E600/E600i,
and 0 to 5 on a E300.
port-set number Enter the keywords port-set followed by the line card’s port pipe.
The range is 0 or 1.
interface
interface
Enter the keyword interface followed by one of the keywords
below and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a SONET interface, enter the keyword sonet followed by
the slot/ port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
summary (OPTIONAL) Enter the keyword summary to display only the total
number of CAM entries.
Defaults none
Command Modes EXEC
Command History
Version 6.5.1.0 Introduced on the E-Series.
1216