Dell Force10 Z9000 - 24 Ipv6 Basics; Clear Ipv6 Fib; Clear Ipv6 Route

24
IPv6 Basics
IPv6 Basic Commands are supported on Dell Force10 E-Series, C-Series, S-Series, Z-Series, or S4810 platforms.
NOTE: For information about the Force10 operating software (FTOS) version and platform that supports IPv6 in each
software feature, refer to the "IPv6 Addressing" chapter of the FTOS Configuration Guide .
clear ipv6 fib
Clear (refresh) all forwarding information base (FIB) entries on a linecard or stack unit.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
clear ipv6 fib linecard slot | stack-unit unit-number
Parameters
slot Enter the slot number to clear the FIB for a linecard.
unit-number Enter the stack member number.
The rang is 0 to 7 for the Z9000 and 0 to 11 for the S4810.
Command Modes EXEC Privilege
Command History
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
clear ipv6 route
Clear (refresh) all or a specific route from the IPv6 routing table.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
clear ipv6 route {* | ipv6-address prefix-length}
835