Dell Force10 Z9000 - Redistribute

Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format followed by the prefix
length in the /x format. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name of
an established route map. Only the following ROUTE-MAP mode
commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all
routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 7.4.1.0 Introduced
Usage
Information
The E-Series software resolves the network address configured by the network command
with the routes in the main routing table to ensure that the networks are reachable via non-
BGP routes and non-default routes.
Related
Commands
redistribute – redistributes routes into BGP.
redistribute
Redistribute routes into BGP.
C-Series, E-Series
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static}
command.
Parameters
connected Enter the keyword connected to redistribute routes from physically
connected interfaces.
static Enter the keyword static to redistribute manually configured
routes. These routes are treated as incomplete routes.
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name
of an established route map. Only the following ROUTE-MAP mode
commands are supported:
• match ipv6 address
526