Dell Force10 Z9000 - Arp Timeout; Clear Arp-Cache

Usage
Information
Retries are 20 seconds apart.
Related
Commands
show arp retries – displays the configured number of ARP retries.
arp timeout
Set the time interval for an ARP entry to remain in the ARP cache.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
arp timeout minutes
Parameters
seconds Enter the number of minutes. The range is 0 to 35790. The default is
240 minutes.
Defaults 240 minutes (4 hours)
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Related
Commands
show interfaces – displays the ARP timeout value for all available interfaces.
clear arp-cache
Clear the dynamic ARP entries from a specific interface or optionally delete (no-refresh) ARP entries from the
content addressable memory (CAM).
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
clear arp-cache [vrf name | interface | ip ip-address] [no-
refresh]
772