Dell Force10 Z9000 - Multiplier; Protocol Lldp (Configuration)

Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Related
Commands
protocol lldp (Configuration) – enables LLDP globally.
show lldp neighbors – displays the LLDP neighbors.
multiplier
Set the number of consecutive misses before LLDP declares the interface dead.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
integer Enter the number of consecutive misses before the LLDP declares the
interface dead. The range is 2 to 10.
Defaults 4 x hello
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if- interface -lldp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
protocol lldp (Configuration)
Enable the LLDP globally on the switch.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults Disabled.
Command Modes CONFIGURATION (conf-lldp)
963