Dell Force10 Z9000 - Advertise Management-Tlv (Interface); Clear Lldp Counters

advertise management-tlv (Interface)
Advertise management TLVs (Type, Length, Value) to the specified interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
advertise management-tlv {management-address | system-
capabilities | system-description | system-name}
To remove advertised management TLVs, use the no advertise management-tlv
{management-address | system-capabilities | system-description
| system-name} command.
Parameters
management-
address
Enter the keyword management-address to advertise the
management IP address TLVs to the specified interface.
system-
capabilities
Enter the keywords system-capabilities to advertise the
system capabilities TLVs to the specified interface.
system-
description
Enter the keywords system-description to advertise the
system description TLVs to the specified interface.
system-name Enter the keywords system-name to advertise the system name
TLVs to the specified interface.
Defaults No default values or behavior
Command Modes INTERFACE(conf- interface -lldp)
Command History
Version 9.1.(0.0) Introduced on the Z9000 and S4810.
clear lldp counters
Clear LLDP transmitting and receiving counters for all physical interfaces or a specific physical interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
clear lldp counters interface
Parameters
interface Enter the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/ port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet followed by the slot/port
information.
958