Dell Force10 Z9000 - Show Ipv6 Flowlabel-Zero; Show Ipv6 Interface

show ipv6 flowlabel-zero
Display the flow label zero setting.
S4810
Syntax
show ipv6 flowlabel-zero
Default Disabled
Command Modes EXEC
Command History
Version 8.3.12.0 Introduced on the S4810.
Related
Commands
ipv6 nd dad attempts – Configure system to set the flow label field in the packets to zero.
show ipv6 interface
Display the status of interfaces configured for IPv6.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ipv6 interface interface [brief] [configured]
[gigabitethernet slot | slot/port] [linecard slot-number]
[loopback interface-number] [managementethernet slot/port]
[port-channel number] [tengigabitethernet slot | slot/port]
[fortyGigE slot | slot/port][vlan vlan-id]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Loopback interface, enter the keyword Loopback
followed by a number from 0 to 16383.
• For the Null interface, enter the keyword null followed by
zero (0).
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a VLAN interface, enter the keyword VLAN.
• For a port channel interface, enter the keyword port-
channel.
brief (OPTIONAL) View a summary of IPv6 interfaces.
850