configured (OPTIONAL) View information on all IPv6 configured interfaces.
gigabitethernet (OPTIONAL) View information for an IPv6 gigabitethernet interface.
linecard
slot-
number
(OPTIONAL) View information for a specific IPv6 linecard or S-Series
stack-unit:
• The range is 0 to 13 on a E1200, 0 to 6 on a E600, and 0 to 5 on
a E300
• The range is 0 to 7 for C-Series
• The range is 0 to 7 for S55 only
• The range is 0 to 11 for S60 and S4810
managementethe
rnet
slot/ port
(OPTIONAL) View information on an IPv6 Management port. Enter the
slot number (0-1) and port number zero (0).
loopback (OPTIONAL) View information for IPv6 loopback interfaces.
port-channel (OPTIONAL) View information for IPv6 port channels.
tengigabitetherne
t
(OPTIONAL) View information for an IPv6 tengigabitethernet
interface.
fortyGigE (OPTIONAL) View information for an IPv6 fortygigabitethernet
interface.
vlan (OPTIONAL) View information for IPv6 VLANs.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale. Added support for the
managementethernet slot/port parameter.
Version 7.8.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
The Management port is enabled by default (no shutdown). If necessary, use the ipv6
address command to assign an IPv6 address to the Management port.
Example
FTOS#
FTOS#show ipv6 int te 0/5
TenGigabitEthernet 0/5 is up, line protocol is up
IPV6 is enabled
Link Local address: fe80::201:e8ff:fe8a:e8f7
Global Unicast address(es):
851
To Next Page
Loading...
