Dell Force10 Z9000 - Change Bootflash-Image

cd
Change to a different working directory.
C-Series, E-Series, S-Series
Syntax
cd directory
Parameters
directory (OPTONAL) Enter one of the following:
• flash: (internal Flash) or any sub-directory
• slot0: (external Flash) or any sub-directory (C-Series and
E-Series only)
Command Modes EXEC Privilege
Command History
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series Original command
change bootflash-image
Change boot flash image from which to boot.
C-Series, E-Series
Syntax
change bootflash-image {cp | linecard linecard-slot | rp}
Parameters
cp Enter the keyword cp to change the bootflash image on the control
processor on the RPM.
linecard linecard-
slot
Enter the keyword linecard followed by the slot number to change
the bootflash image on a specific line card. The C-Series range is 0-7.
The E-Series range is 0 to 13 on the E1200, 0 on 6 on the E600, and 0 to
5 on the E300.
rp
Enter the keyword rp to change the bootflash image on the RPM.
Defaults Not configured
Command Modes EXEC Privilege
Command History
Version 7.5.1.0 Introduced on C-Series
E-Series Original command
63