Dell Force10 Z9000 - Default-Metric

prefix-list prefix-
list-name
(OPTIONAL) Enter the keyword prefix-list followed by the
name of an established prefix list. If the prefix list is not configured,
the default is permit (to allow all routes).
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name (OPTIONAL) Enter the name of the peer group to disable or enable all
routers within the peer group.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
Enter the no debug ip bgp command to remove all configured debug commands for BGP.
default-metric
Allows you to change the metric of redistributed routes to locally originated routes. Use this command with the
redistribute command.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
default-metric number
To return to the default setting, use the no default-metric command.
Parameters
number Enter a number as the metric to be assigned to routes from other
protocols. The range is 1 to 4294967295.
Defaults 0
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
The default-metric command in BGP sets the value of the BGP MULTI_EXIT_DISC (MED)
attribute for redistributed routes only.
Related
Commands
bgp always-compare-med – enables comparison of all BGP MED attributes.
redistribute – redistributes routes from other routing protocols into BGP.
356