Dell Force10 Z9000 - Protocol Lldp (Interface); Show Lldp Neighbors

Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
protocol lldp (Interface)
Enter the LLDP protocol in INTERFACE mode.
C-Series, E-Series, S-Series, Z-Series
Syntax
[no] protocol lldp
To return to the global LLDP configuration mode, use the no protocol lldp command
from Interface mode.
Defaults LLDP is not enabled on the interface.
Command Modes INTERFACE (conf-if- interface -lldp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
Before LLDP can be configured on an interface, it must be enabled globally from
CONFIGURATION mode. This command places you in LLDP mode on the interface; it does not
enable the protocol.
When you enter the LLDP protocol in the Interface context, it overrides global configurations.
When you execute the no protocol lldp from INTERFACE mode, interfaces begin to
inherit the configuration from global LLDP CONFIGURATION mode.
show lldp neighbors
Display LLDP neighbor information for all interfaces or a specified interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show lldp neighbors [interface] [detail]
964