Dell Force10 Z9000 - Router Bgp

match external {1
| 2}
(OPTIONAL) Enter the keywords match external to redistribute
OSPF external routes. You can specify 1 or 2 to redistribute those
routes only.
match internal (OPTIONAL) Enter the keywords match internal to redistribute
OSPF internal routes only.
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name
of a configured route map.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced the ability to substitute IGP cost for MED when a peer/
peer-group outbound route-map is set as internal.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
With FTOS version 8.3.1.0 and later, you can use the redistribute command to advertise
the IGP cost as the MED on redistributed routes. When you set the route-map with metric-type
internal and apply outbound to an EBGP peer/peer-group, the advertised routes corresponding
to those peer/peer-group have the IGP cost set as MED.
When you enter the redistribute isis process-id command without any other
parameters, FTOS redistributes all OSPF internal routes, external type 1 routes, and external
type 2 routes. This feature is not supported by an RFC.
router bgp
Enter ROUTER BGP mode to configure and enable BGP.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as-number Enter the AS number. The range is 1 to 65535 (2-byte), 1 to 4294967295
(4-byte), or 0.1 to 65535.65535 (dotted format).
Defaults Not enabled.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
385