Dell Force10 Z9000 - Gvrp Registration

gvrp registration
Configure the GVRP register type.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
gvrp registration {fixed | normal | forbidden}
To return to the default, use the gvrp register normal command.
Parameters
fixed Enter the keyword fixed followed by the VLAN range in a comma
separated VLAN ID set.
normal Enter the keyword normal followed by the VLAN range in a comma
separated VLAN ID set. This is the default.
forbidden Enter the keyword forbidden followed by the VLAN range in a
comma separated VLAN ID set.
Defaults normal
Command Modes CONFIGURATION-INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Usage
Information
Fixed registration prevents an interface, configured using the command line, to belong to a
VLAN (static configuration) from being unconfigured when it receives a Leave message.
Therefore, Registration mode on that interface is fixed.
Normal registration is the default registration. The port’s membership in the VLAN depends on
GVRP. The interface becomes a member of a VLAN after learning about the VLAN through
GVRP. If the VLAN is removed from the port that sends GVRP advertisements to this device, the
port stops being a member of the VLAN.
Use the forbidden command when you do not want the interface to advertise or learn about
VLANs through GVRP.
Related
Commands
show gvrp – displays the GVRP configuration including the registration.
654