Dell Force10 Z9000 - Interface Null

Parameters
slot/port Enter the keyword ManagementEthernet followed by slot
number (0-1) and port number zero (0).
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.11.1 Introduced on the S55, S60, and S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.4.1.0 Introduced
Usage
Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). Use the ip address
command to assign an IP address to the Management port.
If your system has two RPMs installed, use the show redundancy command to display
which RPM is the Primary RPM.
Example
FTOS(conf)#interface managementethernet 0/0
FTOS(conf-if-ma-0/0)#
Related
Commands
management route – configures a static route that points to the Management interface or a
forwarding router.
duplex (Management) – clears the forwarding information base (FIB) entries on a specified line
card.
speed (Management interface) – clears the FIB entries on a specified line card.
interface null
Configure a Null interface on the switch.
C-Series, E-Series, S-Series, Z-Series
Syntax
interface null number
Parameters
number Enter zero (0) as the Null interface number.
Defaults Not configured; number = 0
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
701