Parameters
seconds
Interval of transmission time between CSNPs on multi-access
networks for the designated intermediate system. The range is 0 to
65535. The default is 10.
level-1 (OPTIONAL) Independently configures the interval of time between
transmission of CSNPs for Level 1.
level-2 (OPTIONAL) Independently configures the interval of time between
transmission of CSNPs for Level 2.
Defaults seconds = 10; level-1 (if not otherwise specified)
Command Modes INTERFACE
Command History
Version 8.3.12.0 Introduced on the S4810.
Usage
Information
The default values of this command are typically satisfactory transmission times for a specific
interface on a designated intermediate system. To maintain database synchronization, the
designated routers send CSNPs.
You can configure Level 1 and Level 2 CSNP intervals independently.
isis hello-interval
Specify the length of time between hello packets sent.
E-Series, S4810
Syntax
isis hello-interval seconds [level-1 | level-2]
To return to the default values, use the no isis hello-interval [seconds]
[level-1 | level-2]
command.
Parameters
seconds
Allows you to set the length of time between hello packet
transmissions. The range is 1 to 65535. The default is 10.
level-1 (OPTIONAL) Select this value to configure the hello interval for Level
1. This value is the default.
level-2 (OPTIONAL) Select this value to configure the hello interval for Level
2.
Defaults seconds = 10; level-1 (if not otherwise specified)
Command Modes INTERFACE
Command History
Version 8.3.12.0 Introduced on the S4810.
876
To Next Page
Loading...
