Dell Force10 Z9000 - Minimum-Links

Example
FTOS(conf)#int port-channel 2
FTOS(conf-if-po-2)#
Related
Commands
channel-member – adds a physical interface to the LAG.
interface – configures a physical interface.
interface loopback – configures a Loopback interface.
interface null – configures a null interface.
interface vlan – configures a VLAN.
shutdown – disables/enables the port channel.
minimum-links
Configure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for the LAG to be also in
“oper up” status.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
minimum-links number
Parameters
number Enter the number of links in a LAG that must be in “oper up” status.
The range is 1 to 16. The default is 1.
Defaults 1
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
If you use this command to configure the minimum number of links in a LAG that must be in
“oper up” status, the LAG must have at least that number of “oper up” links before it can be
declared as up. For example, if the required minimum is four, and only three are up, the LAG is
considered down.
756