Dell Force10 Z9000 - Network Backdoor

Parameters
ip-address Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length format (for
example, /24).
The mask appears in command outputs in dotted decimal format
(A.B.C.D).
route-map map-
name
(OPTIONAL) Enter the keyword route-map followed by the name of
an established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop all
routes).
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
FTOS software resolves the network address configured by the network command with the
routes in the main routing table to ensure that the networks are reachable using non-BGP
routes and non-default routes.
Related
Commands
redistribute – redistributes routes into BGP.
network backdoor
Specify this IGP route as the preferred route.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
network ip-address mask backdoor
To remove a network, use the no network ip-address mask backdoor command.
Parameters
ip-address Enter an IP address in dotted decimal format of the network.
381