Dell Force10 Z9000 - Show Spanning-Tree Pvst

vlan 2 bridge-priority 4096
vlan 3 bridge-priority 16384
FTOS#
Usage
Information
After you enable PVST+, the device runs an STP instance for each VLAN it supports.
Related
Commands
disable – disables PVST+.
show spanning-tree pvst – displays the PVST+ configuration.
show spanning-tree pvst
View the Per-VLAN spanning tree configuration.
C-Series, E-Series, S-Series, Z-Series
Syntax
show spanning-tree pvst [vlan vlan-id] [brief] [guard]
Parameters
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN ID. The
range is 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a synopsis of the
PVST+ configuration information.
interface (OPTIONAL) Enter one of the interface keywords along with the slot/
port information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword port-
channel followed by a number: For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
guard (OPTIONAL) Enter the keyword guard to display the type of guard
enabled on a PVST interface and the current port state.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
1170