Dell Force10 Z9000 - Match Ip Address; Match Ip Next-Hop

match ip route-source – redistributes routes that match routes advertised by other routers.
match metric – redistributes routes that match a specific metric.
match route-type – redistributes routes that match a route type.
match tag – redistributes routes that match a specific tag.
match ip address
Configure a filter to match routes based on IP addresses specified in an access list.
C-Series, E-Series, S-Series, Z-Series
Syntax
match ip address prefix-list-name
To delete a match, use the no match ip address prefix-list-name command.
Parameters
prefix-list-name Enter the name of configured prefix list, up to 140 characters.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names are up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
match interface – redistributes routes that match the next-hop interface.
match ip next-hop – redistributes routes that match the next-hop IP address.
match ip route-source – redistributes routes that match routes advertised by other routers.
match metric – redistributes routes that match a specific metric.
match route-type – redistributes routes that match a route type.
match tag – redistributes routes that match a specific tag.
match ip next-hop
Configure a filter to match based on the next-hop IP addresses specified in an IP access list or IP prefix list.
C-Series, E-Series, S-Series, Z-Series
Syntax
match ip next-hop {prefix-list prefix-list-name}
To delete a match, use the no match ip next-hop {prefix-list prefix-
list-name} command.
287