Dell Force10 Z9000 - Show Ip Ospf Statistics

show ip ospf statistics
Display OSPF statistics.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip ospf process-id statistics global | [interface name
{neighbor router-id}]
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
global Enter the keyword global to display the packet counts received on
all running OSPF interfaces and packet counts received and
transmitted by all OSPF neighbors.
interface name (OPTIONAL) Enter the keyword interface followed by one of the
following interface keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For Port Channel groups, enter the keywords port-
channel
followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
neighbor router-
id
(OPTIONAL) Enter the keyword neighbor followed by the
neighbor’s router-id in dotted decimal format (A.B.C.D.).
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
1095