Dell Force10 Z9000 Reference Guide

• 1 = for OSPF External type 1
• 2 = for OSPF External type 2
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name
of the route map.
tag tag-value (OPTIONAL) Enter the keyword tag to set the tag for routes
redistributed into OSPF. The range is 0 to 4294967295.
Defaults Not configured.
Command Modes ROUTER OSPF
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
IS-IS is not supported on the S-Series platforms.
router-id
Use this command to configure a fixed router ID.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
router-id ip-address
To remove the fixed router ID, use the no router-id ip-address command.
Parameters
ip-address Enter the router ID in the IP address format.
Defaults none.
Command Modes ROUTER OSPF
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
1070

Dell Force10 Z9000 Specifications

General

Switching Capacity	2.56 Tbps
Power Supply	Dual, hot-swappable
MTBF	200, 000 hours
Ports	32 x 40GbE QSFP+
Cooling	Front-to-back airflow
Form Factor	Fixed
Jumbo Frame Support	Up to 9216 bytes
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
MAC Address Table Size	128K
Dimensions (HxWxD)	3.45 in x 17.32 in x 20.0 in