Dell Force10 Z9000 - Management Route

Command History
Version 9.0.0.0 Added support for IPv6.
Version 8.3.11.4 Introduced on the Z9000.
management route
Configure a static route that points to the Management interface or a forwarding router.
C-Series, E-Series, Z-Series, S4810
Syntax
management route {{ip-address mask | {ipv6-address prefix-
length}} {forwarding-router-address | managementethernet}
To remove a static route, use the no management route{{ip-address mask |
{ipv6-address prefix-length}}{forwarding-router-address |
managementethernet}
command.
Parameters
ip-address mask Enter an IP address (dotted decimal format) and mask (/prefix format)
of the destination subnet.
ipv6-address
prefix-length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix format) of
the destination subnet. Enter the IPv6 address in the x:x:x:x::x format
followed by the prefix length in the /x format.
The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
forwarding-
router-address
Enter an IP address (dotted decimal format) or an IPv6 address
(x:x:x:x::x format) of a forwarding router.
managementethe
rnet
Enter the keyword managementethernet for the Management
interface on the Primary RPM.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.0.0.0 Introduced on the Z9000 and added support for IPv6.
Version 8.3.11.1 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
When a static route (or a protocol route) overlaps with Management static route, the static
route (or a protocol route) is preferred over the Management Static route. Also, Management
802