Dell Force10 Z9000 - Max-Hops

To return to the default values, use the no max-age command.
Parameters
max-age Enter a number of seconds the FTOS waits before refreshing
configuration information. The range is 6 to 40. The default is 20
seconds.
Defaults 20 seconds
Command Modes MULTIPLE SPANNING TREE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.5.1.0 Introduced.
Related
Commands
forward-delay – the amount of time the interface waits in the Blocking State and the Learning
State before transitioning to the Forwarding State.
hello-time – changes the time interval between BPDUs.
max-hops
Configure the maximum hop count.
C-Series, E-Series, S-Series, Z-Series
Syntax
max-hops number
To return to the default values, use the no max-hops command.
Parameters
range Enter a number for the maximum hop count. The range is 1 to 40. The
default is 20.
Defaults 20 hops
Command Modes MULTIPLE SPANNING TREE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.5.1.0 Introduced.
Usage
Information
The max-hops command is a configuration command that applies to both the IST and all MST
instances in the MSTP region. The BPDUs sent out by the root switch set the remaining-hops
995