Dell Force10 Z9000 - Neighbor Distribute-List

To delete a description, use the no neighbor {ip-address | peer-group-name}
description command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
text Enter a continuous text string up to 80 characters.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
neighbor distribute-list
Distribute BGP information via an established prefix list.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
neighbor {ip-address | peer-group-name} distribute-list prefix-
list-name {in | out}
To delete a neighbor distribution list, use the no neighbor {ip-address | peer-
group-name
} distribute-list prefix-list-name {in | out} command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to apply the distribute list filter to all
routers in the peer group.
prefix-list-name
Enter the name of an established prefix list.
If the prefix list is not configured, the default is permit (to allow all
routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
363