Dell Force10 Z9000 - Set Automatic-Tag; Set Comm-List Delete

set automatic-tag
Configure a filter to automatically compute the tag value of the route.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
set automatic-tag
To return to the default, enter no set automatic-tag.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
set level – specify the OSPF area for route redistribution.
set metric – specify the metric value assigned to redistributed routes.
set metric-type – specify the metric type assigned to redistributed routes.
set tag – specify the tag assigned to redistributed routes.
set comm-list delete
Configure a filter to remove the specified community list from the BGP route’s COMMUNITY attribute.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
set comm-list community-list-name delete
To insert the community list into the COMMUNITY attribute, use the no set comm-list
community-list-name delete command.
Parameters
community-list-
name
Enter the name of an established Community list, up to 140
characters.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
294