Dell Force10 Z9000 - Ip Rip Receive Version

Defaults Disabled.
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Related
Commands
ip split-horizon – sets the RIP routing updates to exclude routing prefixes.
ip rip receive version
Set the interface to receive specific versions of RIP. The RIP version you set on the interface overrides the version
command in ROUTER RIP mode.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip rip receive version [1] [2]
To return to the default, use the no ip rip receive version command.
Parameters
1 (OPTIONAL) Enter the number 1 for RIP version 1.
2 (OPTIONAL) Enter the number 2 for RIP version 2.
Defaults RIPv1 and RIPv2
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
If you want the interface to receive both versions of RIP, use the ip rip receive
version 1 2 command.
Related
Commands
ip rip send version – sets the RIP version to be used for sending RIP traffic on an interface.
version – sets the RIP version to be used for the switch software.
1243