Dell Force10 Z9000 - Show Ip Bgp Next-Hop

D 70.70.24.0/24 100.10.10.2 0 0 100 200 ?
FTOS#
Related
Commands
show ip bgp – views the current BGP routing table.
show ip bgp next-hop
View all next hops (using learned routes only) with current reachability and flap status. This command only displays one
path, even if the next hop is reachable by multiple paths.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip bgp next-hop
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
The following describes the show ip bgp next-hop command shown in the Example
below.
Field Description
Next-hop Displays the next-hop IP address.
Via Displays the IP address and interface used to reach the next hop.
RefCount Displays the number of BGP routes using this next hop.
Cost Displays the cost associated with using this next hop.
Flaps Displays the number of times the next hop has flapped.
Time Elapsed Displays the time elapsed since the next hop was learned. If the
route is down, this field displays time elapsed since the route went
down.
Example
FTOS>show ip bgp next-hop
Next-hop Via RefCount Cost Flaps Time
Elapsed
63.114.8.33 63.114.8.33, Gi 12/22 240984 0 0 00:18:25
63.114.8.34 63.114.8.34, Gi 12/22 135152 0 0 00:18:13
63.114.8.35 63.114.8.35, Gi 12/22 1 0 0 00:18:07
63.114.8.60 63.114.8.60, Gi 12/22 135155 0 0 00:18:11
FTOS>
406