show running-config snmp – displays the SNMP running configuration.
snmp-server group
Configure a new SNMP group or a table that maps SNMP users to SNMP views.
C-Series, E-Series, S-Series, Z-Series
Syntax
snmp-server group [group_name {1 | 2c | 3 {auth | noauth |
priv}}] [read name] [write name] [notify name] [access access-
list-name | ipv6 access-list-name | access-list-name ipv6
access-list-name]]
To remove a specified group, use the no snmp-server group [group_name {v1 |
v2c | v3 {auth | noauth | priv}}] [read name] [write name]
[notify
name] [access access-list-name | ipv6 access-list-name
| access-list-name ipv6 access-list-name]] command.
Parameters
group_name
Enter a text string (up to 20 characters long) as the name of the group.
The following groups are created for mapping to read/write
community/security-names (defaults):
• v1v2creadg — maps to a community/security-name with
ro permissions.
• 1v2cwriteg — maps to a community/security-name rw
permissions.
1 | 2c | 3 (OPTIONAL) Enter the security model version number (1, 2c, or 3):
• 1 is the least secure version.
• 3 is the most secure of the security modes.
• 2c allows transmission of informs and counter 64, which
allows for integers twice the width of what is normally
allowed.
The default is 1.
auth (OPTIONAL) Enter the keyword auth to specify authentication of a
packet without encryption.
noauth (OPTIONAL) Enter the keyword noauth to specify no authentication
of a packet.
priv (OPTIONAL) Enter the keyword priv to specify both authentication
and then scrambling of the packet.
read
name
(OPTIONAL) Enter the keyword read followed by a name (a string of
up to 20 characters long) as the read view name. The default is
GlobalView and is assumed to be every object belonging to the
Internet (1.3.6.1) OID space.
write
name
(OPTIONAL) Enter the keyword write followed by a name (a string
of up to 20 characters long) as the write view name.
1370
To Next Page
Loading...
