Dell Force10 Z9000 - Cam-Acl

cam-acl
Allocate CAM for IPv4 and IPv6 ACLs.
C-Series, S-Series, Z-Series
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number,
ipv4qos number l2qos number, l2pt number ipmacacl number
ecfmacl number [vman-qos | vman-dual-qos number}openflow {4|8}
Parameters
default Use the default CAM profile settings and set the CAM as follows:
• L3 ACL (ipv4acl): 6
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
• OpenFlow: 0 (disabled)
l2acl number
ipv4acl number
ipv6acl number ,
ipv4qos number
l2qos number ,
l2pt number
ipmacacl number
ecfmacl number
[vman-qos |
vman-dual-qos
number
Allocate space to each CAM region.
Enter the CAM profile name followed by the amount of CAM space to
be allotted. The total space allocated must equal 13. The ipv6acl
range must be a factor of 2.
Enter 4 or 8 for the number of OpenFlow FP blocks.
• 4: Creates 242 entries for use by the OpenFlow controller (256
total entries minus the 14 entries reserved for internal
functionality)
• 8: Creates 498 entries for use by the OpenFlow controller (512
total entries minus the 14 entries reserved for internal
functionality)
Command Modes CONFIGURATION
Command History
Version 9.1.(0.0) Added support for OpenFlow.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-
qos
.
Version 8.2.1.0 Introduced on the S-Series.
Version 7.8.1.0 Introduced on the C-Series.
Usage
Information
You must save the new CAM settings to the startup-config (write-mem or copy run
start
) then reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks and
these cannot be reallocated. The ipv4acl profile range is 1 to 4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
548