Parameters
verbose (OPTIONAL) Enter the keyword verbose to view all VRRP group
configuration information, including defaults.
Command Modes VRRP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Example
FTOS(conf-if-vrid-4)#show con
vrrp-group 4
virtual-address 119.192.182.124
!
show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the FTOS returns No Active VRRP group.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show vrrp [vrrp-id] [interface] [brief]
Parameters
vrrp-id
(OPTIONAL) Enter the Virtual Router Identifier for the VRRP group to
view only that group. The range is 1 to 255.
interface
(OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For Port Channel interface types, enter the keywords port-
channel
followed by the number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale.
• For SONET interfaces, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN interface, enter the keyword vlan followed by
the VLAN ID. The VLAN ID range is from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of information
on the VRRP groups on the E-Series.
1477
To Next Page
Loading...
