Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
The dot1p-priority command changes the priority of incoming traffic on the interface.
The system places traffic marked with a priority in the correct queue and processes that traffic
according to its queue.
When you set the priority for a port channel, the physical interfaces assigned to the port
channel are configured with the same value. You cannot assign the dot1p-priority
command to individual interfaces in a port channel.
rate limit
Limit the outgoing traffic rate on the selected interface.
E-Series
Syntax
rate limit [kbps] committed-rate [burst-KB] [peak [kbps] peak-
rate [burst-KB]] [vlan vlan-id]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per
second (Kbps). On the E-Series, Force10 recommends using a value
greater than or equal to 512 as lower values do not yield accurate
results. The range is 0 to 10000000. The default granularity is
Megabits per second (Mbps).
committed-rate
Enter the bandwidth in Mbps. The range is 0 to 10000.
burst-KB
(OPTIONAL) Enter the burst size in KB. The range is 16 to 200000. The
default is 50.
peak
peak-rate
(OPTIONAL) Enter the keyword peak followed by a number to specify
the peak rate in Mbps. The range is 0 to 10000.
vlan
vlan-id
(OPTIONAL) Enter the keyword vlan followed by a VLAN ID to limit
traffic to those specific VLANs. The range is 1 to 4094.
Defaults Granularity for committed-rate and peak-rate is Mbps unless you use the kbps
option.
Command Modes INTERFACE
Command History
Version 8.2.1.0 Added the kbps option on the E-Series.
1183
To Next Page
Loading...
