Dell Force10 Z9000 - Isis Network Point-To-Point; Isis Password

isis network point-to-point
Enable the software to treat a broadcast interface as a point-to-point interface.
E-Series, S4810
Syntax
isis network point-to-point
To disable the feature, use the no isis network point-to-point command.
Defaults Not enabled.
Command Modes INTERFACE
Command History
Version 8.3.12.0 Introduced on the S4810.
isis password
Configure an authentication password for an interface.
E-Series, S4810
Syntax
isis password [hmac-md5] password [level-1 | level-2]
To delete a password, use the no isis password [password] [level-1 |
level-2] command.
Parameters
encryption-type (OPTIONAL) Enter 7 to encrypt the password using DES.
hmac-md5 (OPTIONAL) Enter the keywords hmac-md5 to encrypt the password
using MD5.
password Assign the interface authentication password.
level-1 (OPTIONAL) Independently configures the authentication password
for Level 1. The router acts as a station router for Level 1 routing. This
is the default.
level-2 (OPTIONAL) Independently configures the authentication password
for Level 2. The router acts as an area router for Level 2 routing.
Defaults No default password. level-1 (if not otherwise specified).
Command Modes INTERFACE
Command History
Version 8.3.12.0 Introduced on the S4810.
Usage
Information
To protect your network from unauthorized access, use this command to prevent unauthorized
routers from forming adjacencies.
880