Dell Force10 Z9000 - Neighbor Distribute-List

route-map map-
name
(OPTIONAL) Enter the keyword route-map followed by the name of
a configured route map.
Defaults Not configured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
neighbor distribute-list
Distribute BGP information using an established prefix list.
C-Series, E-Series TeraScale, S-Series
Syntax
neighbor [ip-address | peer-group-name] distribute-list prefix-
list-name [in | out]
To delete a neighbor distribution list, use the no neighbor [ip-address | peer-
group-name] distribute-list prefix-list-name [in | out] command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to apply the distribute list filter to all
routers in the peer group.
prefix-list-name
Enter the name of an established prefix list.
If the prefix list is not configured, the default is permit (to allow all
routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
Defaults Not configured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information
Other BGP filtering commands include: neighbor filter-list, ip as-path
access-list, and neighbor route-map.
Related
Commands
ip as-path access-list – configures the IP AS-Path ACL.
neighbor filter-list – assigns a AS-PATH list to a neighbor or peer group.
neighbor route-map – assigns a route map to a neighbor or peer group.
426