Dell Force10 Z9000 - Reset

Parameters
conditional
nvram-cfg-
change
Reload if the condition is true. A configuration change to the nvram
requires a switch reload. You must select nvram-cfg-change to
reload the switch.
Command Modes EXEC Privilege
Command History
Version 9.1(0.0) Added ‘conditional’ parameter.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
If there is a change in the configuration, FTOS prompts you to save the new configuration. Or
you can save your running configuration with the copy running-config command.
For information related to the BMP reload options, refer to the Bare Metal Provisioning (BMP)
chapter.
Use the conditional parameter if any configuration changes made to the nvram, such as stack-
group and fanout configurations, must be saved.
Related
Commands
• reset – resets a line card, RPM, or a failed SFM (TeraScale and ExaScale).
• reset stack-unit – resets any designated stack member except the management unit.
reset
Reset a line card, RPM, or a failed SFM (TeraScale only).
C-Series, E-Series
Syntax
reset {linecard number [hard | power-cycle] | rpm number [hard
| power-cycle] | sfm slot number}
Parameters
linecard number Enter the keyword linecard and a number for the line card slot
number. The C-Series range is 0 to 7. The E-Series range is 0 to 13 on
the E1200/E1200i, 0 to 6 on the E600/E600i, and 0 to 5 on the E300.
(Optional) Add the keyword hard or power-cycle (power-
cycle
is C-Series only) to power cycle the line card.
hard Enter the keyword hard to power cycle the line card.
power-cycle Enter the keyword power-cycle after upgrading a C-Series FPGA
to cause the FPGA to be reprogrammed based on the contents of the
FPGA PROM.
131