Dell Force10 Z9000 - Show Ip Bgp Ipv6 Unicast Neighbors

Prefix advertised 0, rejected 0, withdrawn 0
Connections established 3; dropped 2
Last reset 00:00:41, due to Closed by neighbor
Notification History
'OPEN error/Bad AS' Sent : 0 Recv: 1
Local host: 5ffe:11::4, Local port: 179
Foreign host: 5ffe:11::3, Foreign port: 36800
Related
Commands
show ip bgp – view the current BGP routing table.
show ip bgp ipv6 unicast neighbors
Allows you to view the information exchanged by BGP neighbors.
C-Series, E-Series
Syntax
show ip bgp ipv6 unicast neighbors [ipv6-address prefix-length
| ip-address] [advertised-routes | dampened-routes | detail |
flap-statistics | routes]
Parameters
ipv6-address
prefix-length | ip-
address
Enter the IPv6 address in the x:x:x:x::x format followed by the prefix
length in the /x format. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros or enter an IP address in dotted decimal format to reset all
prefixes from that neighbor.
advertised-routes (OPTIONAL) Enter the keywords advertised-routes to view
only the routes the neighbor sent.
dampened-routes (OPTIONAL) Enter the keywords dampened-routes to view
information on dampened routes from the BGP neighbor.
detail (OPTIONAL) Enter the keyword detail to view neighbor-specific
internal information for the IPv6 address family.
flap-statistics (OPTIONAL) Enter the keywords flap-statistics to view flap
statistics on the neighbor’s routes.
routes (OPTIONAL) Enter the keyword routes to view only the neighbor’s
feasible routes.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
536