To remove a network, use the no network ip-address mask [route-map map-
name] command.
Parameters
ip-address
Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length format (for
example, /24).
The mask appears in command outputs in dotted decimal format
(A.B.C.D).
route-map
map-
name
(OPTIONAL) Enter the keyword route-map followed by the name of
an established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop all
routes).
Defaults Not configured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information
FTOS software resolves the network address configured by the network command with the
routes in the main routing table to ensure that the networks are reachable using non-BGP
routes and non-default routes.
Related
Commands
redistribute – redistributes routes into the BGP.
redistribute
Redistribute routes into BGP.
C-Series, E-Series TeraScale, S-Series
Syntax
redistribute [connected | static] [route-map map-name]
To disable redistribution, use the no redistribution [connected | static]
[route-map map-name] command.
431
To Next Page
Loading...
